Configuring and Redistributing a Default Route in EIGRP [Cisco Training] by Nicholas Lee Fagan

Channel:
United States Remote IT Support
Subscribers:
6,530
Published on ● Video Link: https://www.youtube.com/watch?v=4TWB7kkbS0E


Duration: 0:35
2,796 views
7

Official Cert Guide - https://amzn.to/2VwYObT

In this walk through you will see that I use the Null0 interface. The Null0 interface is also called 'the bit bucket' because any packets sent here will be discarded. Null0 is always on & running. The walk through though basically shows you how to configure a static IP route & redistribute it via EIGRP so that it is placed in the routing table of all routers in the zone. . .
=== Remote IT Support ===
https://linktr.ee/remotetechsupport

=== Music ===
https://linktr.ee/nichproductions

=== Beautiful World ===
https://linktr.ee/beautifulworldtravel



Other Videos By Remote IT Support


2013-08-17How to set a maximum password age by Nicholas Lee Fagan
2013-08-17How to make a DHCP Reservation by Nicholas Lee Fagan
2013-08-17How to Create a DHCP Super Scope by Nicholas Lee Fagan
2013-08-17How to Remove Roles by Nicholas Lee Fagan
2013-08-16How to Create a DHCP Scope by Nicholas Lee Fagan
2013-08-16Time Synchronization Across the Network by Nicholas Lee Fagan
2013-07-26How to Configure VLANs to Segment Traffic [Cisco IOS] by Nicholas Lee Fagan
2013-07-26Cabling an IP Phone in Cisco Packet Tracer by Nicholas Lee Fagan
2013-07-26EIGRP Autonomous System and Process IDs [Cisco IOS] by Nicholas Lee Fagan
2013-07-26Using the bandwidth command in Cisco IOS by Nicholas Lee Fagan
2013-07-25Configuring and Redistributing a Default Route in EIGRP [Cisco Training] by Nicholas Lee Fagan
2013-07-25How to Disable Auto-Summarization on EIGRP [Cisco Routing] by Nicholas Lee Fagan
2013-07-24Configuring EIGRP on a Cisco Network by Nicholas Lee Fagan
2013-07-24How to Disable Routing Information Protocol (RIP) by Nicholas Lee Fagan
2013-07-24How to go from RIPv2 to RIPv1 [Cisco] by Nicholas Lee Fagan
2013-07-24How to Enable RIPv2 on a Cisco Router by Nicholas Lee Fagan
2013-07-24How to Enable & Configure RIP Routing Protocol on a Cisco Router by Nicholas Lee Fagan
2013-07-24Cisco Router IP Address Scheme to Conserve on IP Addresses by Nicholas Lee Fagan
2013-07-24How to Remove / Add a Static Route | Cisco Router Configuration by Nicholas Lee Fagan
2013-07-24Cisco Switch Cabling in PKT & Configuration w/DHCP Setup by Nicholas Lee Fagan
2013-07-24Basic Cisco Router to Router Cabling, IP Addressing Scheme & Configuration in PKT