It's alive! (HS700, Walkera G-2D Gimbal) More info in description √

Channel:
Subscribers:
45
Published on ● Video Link: https://www.youtube.com/watch?v=yvwndL0_CIY



Duration: 0:21
77 views
4


5 hours, and 7 cut USB Micro-B cables later, I finally have the gimbal running on the drone's own power source, and not by a wall adapter.

This was accomplished with the mentioned buck connector circuit in the last video. I dialed it into 10 volts, more than the 7.4 minimum, but unnecessary to waste efficiency going up to 12 volts.

The cabling is a mess and I'll be ordering new wires to butcher because most of the cables I had were just charging cables, and were missing the 2 data wires. Without them, I cannot control the camera from the controller, and have to rely on the dodgy "Ophelia GPS" app which doesn't seem to communicate well when I tell it to record, take pictures, etc. Only reliable as a viewfinder.

Didn't get it ready in time to record on my trip to the UP to help my dad, however the fall colors were mostly done anyway.







Tags:
Walkera G-2D
Holy Stone HS700
HS700
HS700 Gimbal