Short three axis zero demo.
Channel:
Subscribers:
2,680
Published on ● Video Link: https://www.youtube.com/watch?v=70uEVJoJ3VM
3This was created to illustrate how the ON INPUT command works in the SBP programming language. Each time the bit contacts the metal block, the controller stops the axis in motion and returns control to the host computer. A jump is executed to the target of the ON INPUT command, where more action is taken.
Other Videos By f15sim
| 2020-04-19 | Repairing a 39 year old H/Z-89 Computer |
| 2019-12-20 | Finished the PiDP 11/70 kit I bought at the last VCFPNW. Finally! |
| 2019-10-05 | Building the SeeMeCNC Rostock MAX v4, Part 2! |
| 2019-09-29 | Building the SeeMeCNC Rostock MAX v4, Part 2! |
| 2019-09-29 | Building the SeeMeCNC Rostock MAX v4! |
| 2019-09-10 | Pulling the cab apart and checking the instruments! |
| 2019-09-02 | Power on and first flight of the ATC-810 IFR Flight Simulator! |
| 2019-09-02 | ATC 810 offload and more unboxing! |
| 2019-08-30 | ATC-810 (Commercial Flight Simulator) Unboxing! |
| 2019-04-24 | MPCNC Build Finish and Test Run! |
| 2019-03-22 | Short three axis zero demo. |
| 2019-03-03 | MPCNC Cutting Table Build |
| 2019-02-23 | MPCNC Motion Demo |
| 2019-01-13 | APG-63(V1) radar panel rebuild overview |
| 2019-01-04 | Building an MPCNC table |
| 2018-12-20 | ShopBot Cuts a Book Scanner... |
| 2018-12-17 | Using my newly built DIY Book Scanner! |
| 2018-10-21 | Centurion MAX! |
| 2018-08-31 | ARRON YOUR LATE |
| 2018-06-15 | Using a hendecagon for holding bins. |
| 2018-02-15 | MOnSter 6502 running a game. |