Four Colour Elven Mage Print

Four Colour Elven Mage Print

Channel:
Australia enhaxed
Subscribers:
87
Published on ● Video Link: https://www.youtube.com/watch?v=1L1tbQLERg8


Duration: 0:29
1 views
0

This is a timelapse of a print of the elven mage model from thingiverse (that I modified for the Palette 2).

I had some issues with retraction so I switched to firmware retraction for this print and it has led to a lot of stringing. The stringing is easy to remove but I want to try to minimise it - I'll try lower temperatures for the filament next time too as that should help.

The problem was that retraction was causing a lump of filament to form at the end of the bowden tube and stopping the print since it would jam. I had just replaced the bowden tube so it's possible I didn't seat it properly in the extruder but after testing



Other Videos By enhaxed


2021-03-02Timelapse 3d Print Iris Box
2021-02-283D Timelapse - Quiver Prototype Bottom Section
2021-01-31Cyberpunk 2077 Loose Ends
2021-01-28Cyberpunk 2077 Gigs
2021-01-27Streaming Test Cyberpunk 2077
2021-01-19Glow in the Dark Jumbo 20 Sided Dice Print Timelapse
2021-01-05Baby Yoda Three Colour Palette 2 Print
2021-01-01USB Holder Print Timelapse
2020-12-31Elephant Figurine Timelapse
2020-12-30Baby Yoda in Three Colours Timelapse
2020-12-30Four Colour Elven Mage Print
2020-11-14Displacer Beast 3d Print Timelapse
2020-10-13Timelapse 3d Print Baby Yoda in Three Colours
2020-10-10Slingbow Arm 3d Print Timelapse
2020-10-07Legolini Print
2020-09-24Fantasy Castle in Mostly Blue Print
2020-09-19Surgical Mask Strap Hibiscus Design (Better Camera Angle)
2020-09-17Plantygon Single Colour Print
2020-09-153d Printing a Green Nurgling with a Blue and Black Mushroom
2020-09-10Timelapse First Dual Colour Model with the Palette 2 Pro S
2019-11-29The Outer Worlds - Final