I have a problem. A Big problem!!!!... Shouldn’t have hooked my trailer up

Channel:
Canada BILLSTMAXX
Subscribers:
165,000
Published on ● Video Link: https://www.youtube.com/watch?v=b3W2H2uAzjE


Duration: 18:49
13,078 views
534

< no description available >



Other Videos By BILLSTMAXX


2020-11-27This is how I make a new oil pressure line for the 1944 2N
2020-11-26Little update on the 2n ford fuel tank
2020-11-25Bill Question and answer #16 billqa@yahoo.com and a few early Christmas cards
2020-11-24Little snow plowing video for you. I’m not sure what the big plow truck did 🤔
2020-11-23We need to do a lot of cleaning and make a new steering housing gasket 1944 Ford 2n
2020-11-22RUST.. Lets build a helicopter landing structure at the base
2020-11-21Farm Sim Saturday.. Let's finish some field clearing and plow and plant the new field
2020-11-201944 2N...Let's connect the back and the front sections then remove the steering/shifter top
2020-11-19Let’s try a cold start on the Ford 800 tractor... -6c or 21f
2020-11-18Mid week Farm sim...Field clean up Hyper Drive
2020-11-16I have a problem. A Big problem!!!!... Shouldn’t have hooked my trailer up
2020-11-15Rust...Adventure/Explore day
2020-11-14American Truck Simulator....Colorado State New DLC
2020-11-14Farm Sim Saturday....Let's Plow open the cleared bush field and plant a crop. Plan for expansion
2020-11-131944 Ford 2N flywheel installation and clutch replace
2020-11-13Bill Question and answer #15 billqa@yahoo.com
2020-11-11This was an awesome water wheel sawmill. Let's figure out how it works
2020-11-09Let's burn the new table down heating this flywheel to remove the ring gear 1944 2N Installation
2020-11-08Rust. Fresh start New custom map.. Let’s gather items and build into a rock
2020-11-07Farm Sim Saturday...More land clearing stump removal
2020-11-06Let's install the input shaft in the 1944 2N...also some brazing to repair a clutch rod "pin" hole