Magnet fail with my Deltago printer

Channel:
United States HL ModTech
Subscribers:
61,400
Published on ● Video Link: https://www.youtube.com/watch?v=mlCbS1kvny4


Duration: 0:44
45 views
0

This little robot print was going swimmingly until the magnets connected to each other.



Other Videos By HL ModTech


2016-11-08Launching our rockets to analysis our data good job Colton and Kyler! #nasa #hlmodtech
2016-11-08This is harambe as a baby and grown harambe Rip harambe Vid creeds Eva
2016-11-08Check out the sweet bird houses my sixth hr students created in tinkercad
2016-11-08The secret to creating airplanes in Mod Tech
2016-11-08Mod tech mannequin challenge #deltaprintr #deltago #3dprinting
2016-11-06Quick fix when your stuff is not printable
2016-11-05Deltago printer four pieces at once
2016-11-05Successful printing with the Deltago at 180c
2016-11-05Potential fix for the arms popping off your Deltago 3D printer
2016-11-05Deltago filament guide
2016-11-05Magnet fail with my Deltago printer
2016-11-05Successful test print with my Deltago printer at 185 degrees Celsius
2016-11-05Adjusting the Deltago so it prints a little higher from the bed
2016-11-05Deltago filament feed issue
2016-11-04Love it when the lessons get pushed to crazy cool levels #woms #nolimit
2016-11-04Tinkercad - A part in a part
2016-11-04Delta go printer success again, as long as I stay at 190 Celsius
2016-11-04My fail at 185 degrees Celsius
2016-11-03Successful Dolphin print using Delta Go
2016-11-03Delta go failed dolphin print
2016-11-03Part 2 of the moveable owl