Delta go failed dolphin print

Channel:
United States HL ModTech
Subscribers:
61,400
Published on ● Video Link: https://www.youtube.com/watch?v=NPcaNmXGhc4


Duration: 0:32
48 views
0

I had printed for straight projects successfully, but this one failed. I have since determined that it was because I shut off the z-hop setting... Note to self, when reading forums... not every fix is intended for me... =) #LessonLearned



Other Videos By HL ModTech


2016-11-05Deltago filament guide
2016-11-05Magnet fail with my Deltago printer
2016-11-05Successful test print with my Deltago printer at 185 degrees Celsius
2016-11-05Adjusting the Deltago so it prints a little higher from the bed
2016-11-05Deltago filament feed issue
2016-11-04Love it when the lessons get pushed to crazy cool levels #woms #nolimit
2016-11-04Tinkercad - A part in a part
2016-11-04Delta go printer success again, as long as I stay at 190 Celsius
2016-11-04My fail at 185 degrees Celsius
2016-11-03Successful Dolphin print using Delta Go
2016-11-03Delta go failed dolphin print
2016-11-03Part 2 of the moveable owl
2016-11-03Part one of the movable owl printed with the Delta go printer
2016-11-03Check this out as the pumpkin skill from earlier this week is used to make these wicked trees! #tink
2016-11-03Taya and Anna's prints, print requesting website
2016-11-03#3Dprinting heart shaped marshmallows #awesome
2016-11-03Better than sliced bread
2016-11-03Check out this keychain #woms
2016-11-03The story keychain #hlmodtech
2016-11-03Tinkercad Slicing - Better than Sliced bread
2016-11-02Anna and Taya launching their rockets