RCBS bullet puller is easy to use!
8Picked up this RCBS bullet puller because I had a bunch of .45 GAP rounds but no longer have a .45 GAP firearm.
This was a very easy item to set up and use. It did make a small mess with powder so you need to be using it somewhere that you will be able to sweep up afterwards.
The video shows it all.
Install and adjust the main body.
Install the collet in the bottom of the body and screw in the top handle.
Place the loaded round into the shell holder and run it up so the projectile is in the collet but the case mouth is not. Tighten the top handle snug and apply a small tap to the vise handle as to pull the ram downward.
To release the projectile just loosen the top handle until the projectile falls out.
Thank you for checking out the video and please be sure to check out my reloading community on X called “Reloading Content” or my profile @DrXBloomGaming