The Wii WIng 2 build with FPV maiden (and slight drama !)
47Here's my build and first flights of the Wii WIng 2... not so much a review of sorts, as I already love it from the original. This one was built a little more with FPV in mind so easier to hit the CG and more space for a camera and lipo.
If you are after a Wii Wing 2, the best place to send a message to G is via this thread at http://www.fpvhub.com/index.php/topic,51495.0.html
The gear I've used in my build is (some affiliate links used) -
Motor (5400kv version) - https://www.banggood.com/DYS-BE1104-1104-Brushless-Motor-5400KV-6500KV-7000KV-2-3S-for-100-120-150-Mini-Multirotors-p-1048677.html?p=E81211714085201408XQ
Receiver - https://www.banggood.com/2_4G-8CH-D8-Mini-FrSky-Compatibel-Receiver-With-PWM-PPM-SBUS-Output-p-1140478.html?p=E81211714085201408XQ
Servos - https://www.banggood.com/1_7G-Low-Voltage-Digital-Servo-Orlandoo-OH35P01-KIT-RC-Car-Parts-p-968283.html?p=E81211714085201408XQ
ESC - https://hobbyking.com/en_us/turnigy-plush-6a-8bec-6g-speed-controller.html?___store=en_us
Props - I was using some 3020 props I got from Banggood, but these aren't found anymore, so I need to look for new ones
VTX - https://www.banggood.com/Eachine-VTX03-Super-Mini-5_8G-72CH-025mW50mw200mW-Switchable-FPV-Transmitter-p-1114206.html?p=E81211714085201408XQ
Camera - AKK-Tech KC28 https://www.amazon.com/dp/B06XKTV8G8?m=ADP3MHCS3NLR7&ref_=v_sp_detail_page (still no European store open as yet)
Lipos - https://hobbyking.com/en_us/turnigy-nano-tech-180mah-2s-25-40c-lipo-pack.html (but we can use slightly bigger ones)
The only other things I used (aside from clear Duck tape) which I haven't already mentioned is Uhu Por to stick it all together, and some 0.9mm piano wire with some Z-Bend pliers to make the push rods.
If you are interested in what I did to blind myself, I pressed the left button on my Dom 3's instead of the right (which would have started the DVR recording) this put it into 3d mode, and then some other mode... and I couldn't see until I'd cycled through them by which point I had gone down in some unknown location. Because it was right at the end of it's lipo, I got a grainy image for a few seconds, before the VTX shut off.
If you liked this video and want to show your support - either through subscribing, using an affiliate link, becoming a Patreon supporter or buying a T-shirt, then check out all the ways you could help out here http://www.currykitten.co.uk/support-me/