Timelapse 3D Print Bed leveling reminder for CR-10 (oops!)

Channel:

Wade Hamel

Subscribers:

3,790

Published on April 13, 2018 10:00:02 PM ● Video Link: https://www.youtube.com/watch?v=VYR8tyK9gQY

Duration: 1:58

27 views

1

This is what happens when you don't pay attention to the orientation of the parts. This totally should have been printed flat side down!

This part shows which direction to turn the knobs to adjust the bed level for the CR-10. It sits on the front rail so it's easy to see. This is important because I always seem to forget the direction - always.

Creality 3D CR-10 Mini: https://www.gearbest.com/3d-printers-3d-printer-kits/pp_778273.html?lkid=13579757

Thingiverse link: https://www.thingiverse.com/thing:2742968

Printer: Creality CR-10 Mini
Slicer settings:
Print Material: PLA
Layer Height: .1mm (Fine)
Wall Thickness: 1.2mm
Top/Bottom Thickness: 1.2mm
Infill Density: 30%
Hot end temp: 200 Degrees Celcius
Bed temp: 57 Degrees Celcius
Initial Layer Bed Temp: 60 Degrees Celcius
Supports: No
Print speed: 60mm/s
Infill Speed: 70mm/s
Travel Speed: 100mm/s
Initial Layer Speed: 30mm/s
Plate Adhesion Type: Skirt
Skirt line width: .4 mm