Toyota Automatic Transmission Filter And Fluid Change
121Like And Follow Me On:
Facebook: https://www.facebook.com/ScorpionMultimedia
Instagram: https://www.instagram.com/scorpion_multimedia
Note: for the drain plug for the transmissioni said 69ft lbs I meant 36ft lbs. I appreciate you guys for watching I hope this was very helpful
Part Numbers:
OEM Transmission Gasket: 35168-52020
OEM Transmission Filter: 35330-0W021
Automatic Transmission Fluid (you choose which of the following you want in your car)
-Royal Purple 01320/301143 Max Atf
-Toyota OEM Automatic Transmission Fluid
-ATF-0T4 Genuine AISIN Toyota Premium Automatic Transmission Fluid
This is for all vehicles with 1NZFE engine with automatic transmission
Toyota Vios/Belta
Toyota Yaris/Echo
Scion xA/ist
Scion xB (1st generation)/Toyota bB generation)
Toyota Raum
Toyota Porte
Toyota Platz
Toyota Ist
Toyota Auris
Toyota Fun Cargo
Toyota Premio
Toyota Allion
Toyota Sienta
Toyota Probox
Toyota Ractis
Toyota Corolla (Axio/Fielder, RunX, Allex)
Procedure
Run through all the gears while stationary a few times
Drive the Crap out of it for 10 min, inluding flooring it on the highway to get to speed, and randomly hitting the gas until it downshifts at speed.(Obey the speed limit)
Run through the gears while stationary again let cool
Find the Drain Plug, it's 10mm allen plug on the driver's side near the wheel
Line up the pan
Open the drain
Let it Drain for approximately 5-10min
Tighten the plug back down 36ft lbs or tighten by hand till can't turn
Put some plastic, cardboard or whatever you have down under the pan
Use a socket to remove all the bolts around the pan (you will need to flex the plastic undertray a bit if you don't want to remove it)
The pan will come off,(yes you can see wires and gizmos inside your transmission)
Now remove 3 bolts from the filter, and discard it.
Put the o-ring on the new filter and install it, with the 3 bolts (the transmission will probably still be dripping) Torque to 8ft lbs
Clean the Pan, including the 2 magnets with paper towel.
Reinstall the pan with the new gasket supplied, make sure gasket doesn't crinkle or anything make sure it goes on flat put a bolt to hold in place
Don't over tighten the pan bolts, 3-5ft lbs max
Wipe everything down so you can watch for leaks
Add 3 Qt of ATF Fluid either Toyota OEM fluid or royal purple like I did
Check the level and add more until it is full(I waited for the car to cool off overnight and used the cool markings on the dip stick)
Make sure no fluid had leaked out while car running or after short drive.
If you'll like to support my channel, you can donate thru my link below:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8PRQJG99YUZLC&source=url