Voron V0 Build - E15 - Toolhead wiring

Channel:
United States Sharp's Arena
Subscribers:
243
Published on ● Video Link: https://www.youtube.com/watch?v=5cdNfa-lX5k


Duration: 21:02
422 views
1

This week on the build it's time to get the toolhead wired and tied into the control board. We are very close to being able to run this printer. Next up is configuring the software which we will cover next week. I hope to see you then and fell free to hop into the discord and chat.

Guilded Link: https://www.guilded.gg/i/ExP8ZG9E
(Dead) Discord Link: https://discord.gg/Dzke8e6



Other Videos By Sharp's Arena


2021-01-14Voron 2.4 - E2 - Z-axis Motion system
2021-01-12Sharp's Garage - Plans for the WJ
2020-12-24Voron V2.4 - E1 - Intro & Frame
2020-12-22Merry Christmas
2020-12-17Voron V0 Build - E18 - First Prints & Serial Request
2020-12-15Book Review - The Extinction Cycle
2020-12-10Voron V0 Build - E17 - Temporary Panel Mounting
2020-12-07NFA Trusts - How to, and Why you should
2020-12-03Voron V0 Build - E16 - Software and Firmware config
2020-12-01Book Review - Chronicles of Max [REDACTED]
2020-11-26Voron V0 Build - E15 - Toolhead wiring
2020-11-24Jeep Update - Fall 2020
2020-11-19Voron V0 Build - E14 - Wiring the Electronics
2020-11-17Reloading Content, Possibly??
2020-11-12Voron V0 Build - E13 - Electronics Mounting
2020-11-10Thoughts on Fall and the Change
2020-11-05Voron V0 Build - E12 - Final Frame Assembly
2020-10-29Voron V0 Build - E11 - Toolhead assembly
2020-10-27Starship's Mage review pt 2
2020-10-21Voron V0 Build - E10 - Feet & Belt routing
2020-10-15Voron V0 Build - E9 - Gantry Assembly


Tags:
Sharp's Arena
Sharps Arena
Sharpshot21
Voron
V0
Build
DIY
Assembly
3D
Printer
Printing