Voron V0 Build - E16 - Software and Firmware config

Channel:
United States Sharp's Arena
Subscribers:
243
Published on ● Video Link: https://www.youtube.com/watch?v=sNDqOU403g8


Duration: 38:17
596 views
2

This week it's time for getting the software and firmware setup and configured for the printer. It's not too hard a process, but it does take a little time and there are some pitfalls to avoid as well.

Guilded Link: https://www.guilded.gg/i/ExP8ZG9E
(Dead) Discord Link: https://discord.gg/Dzke8e6



Other Videos By Sharp's Arena


2021-01-21Voron 2.4 - E3 - A/B Drive and Idlers
2021-01-19Book Review - Starship's Mage Red Falcon
2021-01-14Voron 2.4 - E2 - Z-axis Motion system
2021-01-12Sharp's Garage - Plans for the WJ
2020-12-24Voron V2.4 - E1 - Intro & Frame
2020-12-22Merry Christmas
2020-12-17Voron V0 Build - E18 - First Prints & Serial Request
2020-12-15Book Review - The Extinction Cycle
2020-12-10Voron V0 Build - E17 - Temporary Panel Mounting
2020-12-07NFA Trusts - How to, and Why you should
2020-12-03Voron V0 Build - E16 - Software and Firmware config
2020-12-01Book Review - Chronicles of Max [REDACTED]
2020-11-26Voron V0 Build - E15 - Toolhead wiring
2020-11-24Jeep Update - Fall 2020
2020-11-19Voron V0 Build - E14 - Wiring the Electronics
2020-11-17Reloading Content, Possibly??
2020-11-12Voron V0 Build - E13 - Electronics Mounting
2020-11-10Thoughts on Fall and the Change
2020-11-05Voron V0 Build - E12 - Final Frame Assembly
2020-10-29Voron V0 Build - E11 - Toolhead assembly
2020-10-27Starship's Mage review pt 2


Tags:
Sharp's Arena
Sharps Arena
Sharpshot21
Voron
V0
3D
Printer
Printing
DIY
Assembly
Build
Instructions
Kilpper
Octoprint
Raspberry Pi