433Mhz Garage Door Opener - Universal Remote - Easy How to Program

Channel:

Westy Crypto

Subscribers:

6,220

Published on June 17, 2017 3:30:05 AM ● Video Link: https://www.youtube.com/watch?v=_zKZReFjVDY

Category:

Tutorial

Duration: 3:16

1,144,537 views

2,286

If this one does not work try:
https://www.youtube.com/watch?v=RM_xgNsP4sQ
or
https://www.youtube.com/watch?v=l-k_XvkZ0jE

Instructions thanks to IVYb's suggestion
SEE BELOW
In This Video, I show you the simple steps to firstly reset your garage door remote and then show you how to program it. Simple step by step garage remote how to guide.
Steps:
================================
|Clear existing Memory Settings|
================================

1. Hold down the A & B Button (the two closest to the LED Light)
2. While Holding down Button A (Left) Press (Slowly) button B -right one, 3 times
3. Then Release Button A.
Now no button presses will operate the light (LED)

================================
|How to Set New Learning Code |
================================
This is a 2 Stage Process:

=========
|STAGE 1| Programming New REMOTE
=========

1. Get old door opener and the new non-programmed one close to each other
2. One the old Remote that works, hold down the button that works on the door
3. Now Press and hold the button (The LED will Flash a few times and then be raon the new remote you wish to operate your door with.
4. Hold this button down until the LED light goes Solid
5. Stage one Complete

=========
|STAGE 2| Syncing to Door Master Controller (If Above does not work)
=========

1. Put Garage Door Master Controller into learning mode and wait till it is in listening mode (Each type is different = refer to your owners manual) and then press the button you have configured.