自己 DIY 轉吧 1.5V 小型馬達,安裝電池的時候,是彈簧的負極,要先裝 Do your own DIY turn 1.5V small motor
1.5V small motor, the battery is the negative pole of the spring, you must install it first
圖片文字 https://zfly9.blogspot.com/2021/09/15bktlzpek9d.html
段落 00:00 電池3號,現在明白了,彈簧的負極,要先裝
段落 03:25 用尖嘴鉗,用斜口鉗,轉一轉,電線去頭去尾
大家能否斗內一些錢給我做研究
窮到發慌,沒錢了快餓死,如果可以的話,請大家贊助我
維持該YT頻道能夠正常運作,您可以小額斗內一些錢給我
https://zmarkchang.blogspot.com/2019/07/donate.html
Please donate to me if you can, thank you very much
https://zmarkchang.blogspot.com/2019/07/donate.html
Donate to help keep my YouTube running
When the battery is installed, the spring is negative
電池在裝的時候,彈簧是負極
Install the negative electrode first
負極先裝上
I did not know much before
我以前是不太知道
Sometimes the positive electrode is installed first,
有時候正極先裝,
and the spring is hard pressed
那個彈簧用硬壓的
As a result, the spring will be crooked
結果那個彈簧都會歪掉
The negative spring will be skewed
負極的彈簧都會歪掉
It is crooked and slanted just a few times
裝沒幾次就歪歪斜斜的
When installing, the negative electrode is installed first
在裝的時候,是負極先裝
The positive part, press it a little, and install it
正極的部分,稍微壓一下就裝上
Since there are no plastic fan blades
由於沒有塑膠的風扇葉片
I use water and electricity tape instead
我用水電膠帶,替代
Cut off, here
斷了一截,在這裡
Actually, it is not done like this
實際上,不是這樣弄的
The one on the left is needle nose pliers
左邊的這個是尖嘴鉗
The one on the right is called diagonal pliers
右邊的這個叫做斜口鉗
It is not right, it is not done
這樣也不對,沒有弄好
The back is also cut until it breaks off
後面也是剪到斷掉
I later thought that I would need to turn around
我後來想到,要用轉一轉的
Try again
重新弄過
Cut him a little, then turn around
稍微的給他剪一剪,然後轉一轉
Take it out, it is very simple
抽出來,非常的簡單
This is the more successful way
這是比較成功的方式