How to Operate a Stratus 5 Water Oxygen Concentrator (Set Up 3B 5L Adjust Liter Levels)
Operating a Stratus 5 Oxygen Concentrator is fairly straightforward, but it's important to follow the proper steps for safe and effective use. Here’s a general guide:
1. Set Up the Stratus5 Machine
Location: Place the Stratus 5 oxygen concentrator on a flat, stable surface in a well-ventilated area. Ensure that it’s at least 6 inches away from walls or furniture to allow proper airflow.
Check Filters: Ensure the air filter is clean and correctly installed. The concentrator requires clean filters for optimal performance.
2. Connect the Tubing
Attach the nasal cannula or oxygen mask to the oxygen outlet on the front of the machine.
Make sure the tubing is securely connected to avoid air leaks.
3. Power On the Machine
Plug the oxygen concentrator into a grounded electrical outlet.
Turn on the machine by pressing the power switch (usually located on the front or side of the unit).
After turning it on, the machine will start drawing in room air, which it will filter and concentrate to deliver oxygen.
4. Set Oxygen Flow Rate
Use the flow rate control knob or buttons (depending on the model) to adjust the oxygen flow to the prescribed rate. Your healthcare provider will have set a specific flow rate (e.g., 2 liters per minute).
The flow meter or digital display on the machine should show the exact flow rate.
5. Ensure Proper Operation
Listen for any alarms or unusual sounds. The machine may sound an alarm if there are issues with airflow, power, or oxygen delivery.
Check that oxygen is flowing through the tubing by placing the nasal cannula or mask close to your nose or mouth and feeling the air.
6. Use and Monitor
Place the nasal cannula prongs into your nostrils or put on the oxygen mask.
Breathe normally while using the machine.
Monitor the oxygen levels if you have a pulse oximeter to ensure you are receiving the correct amount of oxygen.
7. Turning Off the Machine
When finished using the oxygen concentrator, turn off the machine using the power switch.
Disconnect the nasal cannula or mask, and ensure the machine is turned off before unplugging it from the electrical outlet.
8. Regular Maintenance
Filter Cleaning: Clean or replace the air filter as recommended in the user manual, typically once a week or as needed.
Tubing and Cannula Replacement: Change the nasal cannula or oxygen mask and tubing periodically, as advised by your healthcare provider.
Safety Tips:
Avoid using the machine near open flames or while smoking.
Keep the concentrator in a well-ventilated area and do not block the air intake or exhaust ports.
Ensure that the power cord and tubing are not damaged, and avoid tripping over them.
For specific instructions, consult the user manual of your Stratus 5 Oxygen Concentrator, as the exact controls and setup can vary slightly by model. Always follow any instructions provided by your healthcare provider for safe and effective oxygen therapy.
Disclaimer: As an Amazon Associate I earn from qualified purchases.
#ad