Water sensor test & calibrate ( The Algae Co2 Scrubber )
Hi all today I'm going through the testing of the water temperature sensors for the Algae Co2 Scrubber.
This test is to make sure that all 4 sensors have similar readings in the same body of water, if not the sensors need to be adjusted, this could be done via the code, the exported and saved results (if you are recording) or adjusting the resistor (This would need to be done via very low tolerance)
If you need to watch from the start check out the playlist:
https://www.youtube.com/playlist?list=PLqTrJlcRXDhn7XZvojDIINuW2GRUuskCI
Or if you need a tutorial on how to setup and code the water temperature sensor DS18B20 for Arduino check out this video: https://youtu.be/GQ5WSfNrBMk
Check out Josephine's channel
https://www.youtube.com/channel/UChRIIUpVIG-HMIYoMM3WSSw
Check out and subscribe to my Twitch channel
https://www.twitch.tv/cc_davion
DS18B20
arduino
thermometer
arduino nano
arduino projects
arduino uno
best thermometer
digital thermometer
mercury thermometer
temperature thermometer
thermistor
thermocouple
accurate digital thermometer
accurate thermometer
co 2
co2
algea
blue algea
blue green algea
calculating carbon footprint
carbon dioxide
carbon emission
co2 is
red algea
algea in water
black beard algea
brown algea
brown algea in aquarium
c02
car co2
carbon capturing
carbon dioxide co2
carbon dioxide emissions