3D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 18
Channel:
Subscribers:
1,700
Published on ● Video Link: https://www.youtube.com/watch?v=FIu7jd0jEew
9First quad gantry level with the Nitehawk-SB toolhead PCB.
In the video I state that it's the first gantry level with the carbon fiber gantry, but this is incorrect. I had done a successful gantry level with the original toolhead PCB, with the 14 wire harness draped over the top of the printer frame.
The Nitehawk-SB uses USB protocol to send/receive power and information to the toolhead, rather than using individual wires. It's an alternative to the more common CANBUS option, which uses the same principal but with a different protocol.
Other Videos By TomsProjects
| 2025-06-04 | 3D Printed R2D2 - Part 114 |
| 2025-04-11 | 3D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 18 |
| 2025-04-11 | 3D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 17 |
| 2025-03-19 | Amiga 1000 - Part 8 |
| 2025-02-26 | Amiga 1000 - Part 7 |
| 2025-02-17 | Amiga 1000 - Part 6 |
| 2025-02-17 | Amiga 1000 - Part 5 |
| 2025-02-09 | Amiga 1000 - Part 2 |
| 2025-02-09 | Amiga 1000 - Part 4 |
| 2025-02-09 | Amiga 1000 - Part 3 |
| 2025-02-09 | Amiga 1000 - Part 1 |
| 2024-11-12 | Pacific Northwest R2 Builders Club: 2024 R2 Northwest Builders Expo - Aftermath. |
| 2024-11-12 | Pacific Northwest R2 Builders Club: 2024 R2 Northwest Builders Expo - Showtime! |
| 2024-11-12 | Pacific Northwest R2 Builders Club: 2024 R2 Northwest Builders Expo - Prep and setup. |
| 2024-11-05 | 3D Printed R2D2 - Part 112 |
| 2024-11-05 | 3D Printed R2D2 - Part 113 |
| 2024-10-31 | 3D Printed R2D2 - Part 111 |
| 2024-09-11 | 3D Printed R2D2 - Part 110 |
| 2024-09-11 | 3D Printed R2D2 - Part 109 |
| 2024-09-02 | 3D Printed R2D2 - Part 108 |
| 2024-09-02 | 3D Printed R2D2 - Part 107 |