Cheapest DIY Amazon Cybersecurity Tool + Build Guide! #cybersecurity #educationonly #shorts #diy
1,524This short shows the cheapest DIY Amazon hacking tool you can build to fight tariffs and still get your first cyber security tool without breaking the bank. I walk through the hardware I used, show the custom GhostStrats theme and boot screens I made, and give a quick overview so you can get it running. All files including the Bruce firmware, boot animations, and theme assets are available in our community Proton Drive. Links below.
What you will find in this short
• A low cost DIY hacking tool you can buy on Amazon
• Quick setup overview and theme install notes
• Custom GhostStrats theme and boot screens included
• Files and firmware hosted on Proton Drive for community access
Links and downloads
• Proton Drive community folder with firmware and boot screens Use the Discord invite to get the Drive information https://discord.gg/bsQg8rdwqm
• Bruce firmware flasher https://bruce.computer/flasher
• Amazon product link https://amzn.to/3WtA1Uc
• LilyGo product page https://lilygo.cc/products/lilygo®-ttgo-t-display-1-14-inch-lcd-esp32-control-board?srsltid=AfmBOoqgvccs3k-29alj0aGxkDJL3cze0ZqlJs8IstDkIzuaSSVjSGnd
Discounts and codes
LilyGo code GhostStrats save 5%
Responsible use disclaimer
This video is for education and lawful security research only. Only use these tools on systems you own or where you have explicit permission to test. Do not attempt unauthorized access to networks or devices. I am not responsible for misuse.
Hashtags
#hackingtool #cybersecurity #infosec #pentesting #ethicalhacking #privacy #hardwarehacking #diy #diytech #tutorial #ghoststrats #lilygo #brucefirmware #savemoney #tariffs #iotsecurity #buildyourown #securitytools
Install Bruce on your LilyGo TTGO
1. Power off the device.
2. Hold down the boom button and keep it held.
3. While still holding the boom button, plug the device into your computer with a data USB cable.
4. Open your browser and go to the Bruce web flasher page: https://bruce.computer/flasher
5. On the flasher page click the latest firmware release.
6. Choose LilyGo from the vendor list.
7. Click TTGO from the device list.
8. Click connect in the top right. you should see your device appear.
9. Follow the on screen prompts. accept any confirmations and continue until the installer starts.
10. Wait for the installation to finish. when it completes the flasher will show success.
11. Safely eject and unplug the device. power it on normally. it should boot with the new Bruce firmware.
Quick verification and tips
• If the device does not appear when you click connect, try a different USB cable, use a different USB port, or press and hold the boom button again while plugging in.
• Make sure the USB cable supports data not just charging.
• If your computer needs drivers on Windows, install the CP210x or CH340 drivers depending on your board.
• Back up any files on the device before flashing if you want to keep them.
• After flashing, install your GhostStrats theme and boot animations as usual.
Responsible use
This guide is for lawful security research and education only. only use on devices and networks you own or where you have explicit permission to test. I am not responsible for misuse.