How To: Put on a Tail Guard on a skateboard

Channel:

sam kupper

Subscribers:

5,070

Published on August 17, 2017 11:44:46 PM ● Video Link: https://www.youtube.com/watch?v=Tbi34qhWmZ4

Category:

Tutorial

Duration: 2:21

19,344 views

191

How To: Put on a Tail Guard/Tail Bone on a skateboard.

Side note: I only put on two of the sex bolts, because the way i skate i tend to completely, over time wear down the right side of the tail guard, so this way i have an extra set of bolts.

If you are sure of the holes you marked you could just drill and set up the tail guard but i like to recheck as much as i can.

There are also two types of tail guards i have seen...the one that i have here, and the one that is just 3 small holes and has just threaded screws, so note im only using the one shown.

- The Tailbone is a 8" wide fits the old school/reissue decks.

Tools:
(1) Drill
(1) 7/32" drill bit
(1) Screw Driver - Phillips Head
(1) Clamp - Optional
(3) Sex Bolts - should come with online orders
(1) Tail Bone
(1) skateboard