gStAv's mini solenoid PCB setup for GUN4IR, the easy way step-by-step
Channel:
Subscribers:
1,770
Published on ● Video Link: https://www.youtube.com/watch?v=rYNt450ZiIM
This is how I built my solenoid pcb needed for solenoid control with the great GUN4IR system. Remeber that this is just my take but I found it easy enough to follow VS the form factor when finished and easilly fit smaller guns with tight space.
What you need:
------------------------
1x Double-sided circuit breadboard
1x MOSFET (L type - Logic)
1x diode 1N4007
1x 1k Ohm 1/4W
1x 100k Ohm 1/4W
Soldering iron
5x Wires (GND/VCC/S1/S2/signal)
Good to have:
----------------------
Shrink tubing
Patiens
Same setup can be used to run a motor just as a solenoid, just use the output 5 on the arduino instead of 7. Needed for bigger motors otherwise the transistor setup can be used.
Good luck. 😊