How to Configure RIP Version 1 (RIPv1) on Cisco Router in Cisco Packet Tracer | SYSNETTECH Solutions

Channel:

SYSNETTECH Solutions

Subscribers:

12,800

Published on June 6, 2017 6:54:35 PM ● Video Link: https://www.youtube.com/watch?v=x3Oz4Y4j9GM

Category:

Guide

Duration: 12:12

12,195 views

94

This video shows you how to configure RIP (Routing Information Protocol) using the Cisco Packet Tracer network simulator program.

✅ S U B S C R I B E ► http://goo.gl/8d0iG9
✅ Article ► https://www.sysnettechsolutions.com/en/configure-rip-routing-in-cisco-packet-tracer/

To configure #RIP Version 1 (#RIPv1):

Step 1: If you have not installed Packet Tracer before, please refer to the following videos to install it on Windows, Linux, macOS.

Windows ➦ https://www.youtube.com/watch?v=pNLhTixgCXg
Linux / Ubuntu ➦ https://www.youtube.com/watch?v=rwGuAbiGPdc
macOS ➦ https://www.youtube.com/watch?v=0dnKRR9nGFs

Step 2: After installing it, add two Cisco Routers, Cisco Switch, and four PCs to the workspace.

Step 3: After creating a network topology with two routers, cabling all the devices you have added to the workspace. Then add Serial Interfaces to the Routers and run the Routers.

Step 4: After preparing the topology, define an IP block for the connection between the routers. In addition, specify an IP block for the LANs under the Routers and note them in the workspace.

Step 5: Assign IP addresses to the PCs you add according to the networks they are connected to.

Step 6: Make sure to wire the routers with the Serial DCE cable.

Step 7: Watch the entire video to enable the RIPv1 protocol and verify the configuration.

Step 8: Don't forget to subscribe to our YouTube channel for more videos on Cisco Routing training!


────BEST PRODUCT FOR CISCO TRAINING──────

✅ Buy ► http://bit.ly/CiscoNetworkingEssentials


──────────── RELATED VIDEOS ──────────────

➊ How to Configure RIP Version 2
➦ https://www.youtube.com/watch?v=RwiKhrLkHgw

➋ Cisco Router Modes
➦ https://www.youtube.com/watch?v=JJ-bYBEP88E

➌ How to Use Packet Tracer
➦ https://www.youtube.com/watch?v=2VL3rjZ_Wmw

➍ How to Configure EIGRP
➦ https://www.youtube.com/watch?v=vhVmum82qjE

➎ How to Configure OSPF
➦ https://www.youtube.com/watch?v=xF4xd4cEDXg


───────────────FOLLOW US───────────────────

✔ Facebook
➦ https://www.facebook.com/SysnettechSolutions/

✔ Twitter
➦ https://twitter.com/SysnettechS/

✔ Pinterest
➦ https://www.pinterest.com/SysnettechS/

✔ Instagram
➦ https://www.instagram.com/sysnettech_solutions/

✔ LinkedIn
➦ https://linkedin.com/in/tolqabaqci/

███████████████████████████████████████████