How to set up Aztech DSL600EW modem router in 1 minute.
2Aztech DSL600EW configuration step by step:
Please follow the below steps to configure the Aztech DSL600EW modem
Establish a connection between the device and the router via network cable or Wi-Fi (if there’s a WIFI password you have to check the bottom of the router. If you turn the router over, you should see a sticker, and one of the pieces of information should say something like “Wi-Fi Password” or “WPA passcode.”)
Open a browser and type 192.168.1.1 in the address bar
You will be prompted to enter your Username: admin and Password: admin
Upon Login successfully, the Setup Wizard page will be displayed. Click on Step 1
Type ADSL Username and Password and Select PPPoE Protocol
Type VPI and VCI , VPI should be 0 in case DSP is Ogero and 8 in case DSP is GDS while VCI should
be 35 then click Next
We prefer to keep the same Wifi Name to configure it later using the advanced mode, and you just need to click Next
We prefer to keep Wireless Security disabled to configure it later using advanced mode and you just need to click Next
Keep the default modem’s password by just clicking Next
When you see the Summary page, click Finish
Wait for the modem to save the configuration and try to connect to the internet
For those who have their routers configured, they will be directed to the “Basic Home” page
You can use the basic home page to check or reconfigure the modem
Click Basic then Quick start on the left side menu
Type ADSL Credentials in User ID and Password Textboxes
Select PPPoE LLC as Protocol then type VPI and VCI
VPI should be 0 if DSP is Ogero and 8 if DSP is GDS while VCI should be 35 then click Connect
After clicking Connect you have to click on Save Settings in the top left corner
To configure Wireless, Click Wireless in the top menu then click Setup on the left
Make Sure Access Point is enabled then in Primary SSID type wireless name and click Apply
You may need to connect your device again to the new Wi-Fi name
Click on Security on the left side menu then Select Specified SSID
Choose WPA then WPA2 options
In the Pre-Shared Key type the wireless password (safest passwords are long and contain at least 8 digits
of mixed letters, and numbers)
Click Apply and Save Settings in the upper left corner then restart the router.
How to set up Aztech DSL600EW modem router in 1 minute.