XMG FUSION 15: Replacing the Spacebar
68Assembly:
- Make sure both metal stabilizer bars are fully clipped in
- If they are clipped in, they should be able to move around freely
- Make sure that the shorter bar will point towards the LCD screen
- Place the longer bar into the lower notches
- Gently place the shorter bar into the upper notches
- You might need a thin screwdriver to push the shorter bar into the notch from outside
- Once all 4 tips are into their notches, the Spacebar should be centered and wiggle freely without being slanted
- Now push it down in the middle to clip it into the keyboard switch below
Disassembly:
- Clip-out the spacebar from the switch by lifting it first at the top, then at the bottom
- Now gently wiggle the keyboard around to remove the stabilizer bar from eatch notch
This laptop sample did not have any screws in the base, that's why the flexing is a bit more pronounced than it would normally be.
Music: Apero Hour by Kevin MacLeod
Licence: CC-BY
Source: https://filmmusic.io/song/3375-apero-hour/