RotaryCraft Tutorial - CVT Unit with Extractor Setup (FTB 1.6.4)

Channel:

TKH

Subscribers:

16,700

Published on May 18, 2014 5:35:51 PM ● Video Link: https://www.youtube.com/watch?v=VqZ9hhYtpiI

Game:

Minecraft (2011)

Category:

Tutorial

Duration: 9:09

6,824 views

53

Instead of using a Gearbox you can use a CVT Unit to change Speed or Torque ratio. A little hard to craft, but makes the life so much easier. An important feature is the ability to change between two different predefined modes with a Redstone signal. I will demonstrate this together with an Extractor from a previous tutorial.

This is the fifth part of my RotaryCraft tutorial mini series, so if you are new to the mod you should go back to the "Getting Started" video before going into this one:
http://youtu.be/KUREqm_iLXc

In this video I will basically only go through the CVT Unit. However, the following items are also used, and most of them are covered in earlier tutorials.
Gasoline Engine
Gas Turbine
Shaft Unit
Diamond Shaft
Dynamometer
Lubricant
Bevel Gear

---

If you like what you see, please make me aware of it in form of a like or a comment. If not, then tell me what you think I should improve. And of course, subscribe if you want to see more.


I can be found on both Twitter and Facebook as well, for video announcements and updates. They are also the preferred ways to send a non-video related question or comment. I also have a page on Twitch!
https://twitter.com/therealtkh
https://www.facebook.com/therealtkh
http://www.twitch.tv/therealtkh/


Game details:
http://minecraft.net
Feed the Beast - 1.6.4 Monster 1.1.1
http://feed-the-beast.com


Music:
"Peace of Mind" by Kevin MacLeod (incompetech.com)

Other Statistics