3D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 13

Channel:
TomsProjects
Subscribers:
1,700
Published on ● Video Link: https://www.youtube.com/watch?v=jjb28HTTFp0


Duration: 2:00
430 views
5

Pushing plastic! All motors working, quad gantry level OK. Next step is to calibrate the extruder to make sure it's pushing the correct amount of filament out.

The toolhead wiring is currently the LDO 14 pin connector plus the additional 2 pin connector that's for the neo pixel LED's. I've decided to go with a Nitehawk-SB umbilical system. This will turn the 16 wires into 4, or 5 as the ground wire is separated into 2 wires on one end. It's basically the same thing as CAN BUS but it uses the USB protocol.



Other Videos By TomsProjects


2024-11-053D Printed R2D2 - Part 113
2024-10-313D Printed R2D2 - Part 111
2024-09-113D Printed R2D2 - Part 110
2024-09-113D Printed R2D2 - Part 109
2024-09-023D Printed R2D2 - Part 108
2024-09-023D Printed R2D2 - Part 107
2024-07-293D Printed R2D2 - Part 106
2024-07-093D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 15
2024-07-093D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 14
2024-07-093D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 16
2024-07-093D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 13
2024-07-093D Printed R2D2 - Part 105
2024-04-233D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 12
2024-03-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 11
2024-03-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 10
2023-12-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 9
2023-12-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 8
2023-12-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 7
2023-11-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 5
2023-11-073D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 6
2023-10-063D Printer Voron 2.4 Rev. C 350mm - Build Progress Part 4


Tags:
3D Printing
Voron 2.4
Nitehawk-SB